USING THE AGC-4P PERSONAL GATE CONTROLLER.
(Solenoid Version)
- Wire the system as shown in the "AGC-4P SYSTEM WIRING
DIAGRAM" shown below. Connect the power cord of the main unit
(AGC-4P) to a 120 VAC outlet.
- Locate the Light Stand (Optional) in a visible position in front of
the gate. Position the StopWatch Timer Foot Switch (Optional) across the
path of the bicycle at a suitable distance from the gate (for best results
the switch can be mounted to a larger board).
- For the first race, and all subsequent races the (GATE) output is
automatically active when the green light is lit.
- Use the Start switch to start the staging sequence. Pushing the
switch will start the sequence. There is a 5-second delay to allow the
rider to get set on the bicycle. The staging sequence will follow the
delay and when the Green light turns on, the gate will drop and the timer
will start. When the bicycle tire travels over the Foot switch, the timer
will stop. The 5-second delay can be disabled by
turning off switch 2 on the front panel.
- Repeat items 3 and 4 as long as desired.
The StopWatch timer will switch from
0.01-second resolution to 0.1-second resolution at 19.99 seconds, rolling over
to 20.0 seconds. The timer will stop counting at 199.9 seconds. If the timer is
allowed to continue counting, the display will not reset when a new sequence is
started. To enable a reset, the timer must be stopped by either activating the
Foot switch or unplugging the timer module. The timer is reset on the Red light
in the staging sequence.
Switch 1 is the ABA/NBL switch.
Switch 3 is used in conjunction with NBL for either “Random” or “Regular Gate”.
